Buparlisib Hydrochloride (BKM120 Hydrochloride) is a pan-class IPI3Kinhibitor, withIC₅₀of 52 nM/166 nM/116 nM/262 nM forp110α/p110β/p110δ/p110γ, respectively.

Buparlisib (BKM120) exhibits 50-300 nM activity for class I PI3K’s, including the most common p110α mutants. Additionally, NVP-BKM120 exhibits lower potency against class III and class IV PI3K's, where 2, 5, >5, and >25 μM biochemical activity is observed for inhibition of VPS34, mTOR, DNAPK, and PI4K, respectively^[1]. Buparlisib (BKM120) induces multiple myeloma (MM) cell apoptosis in both dose- and time-dependent manners. Buparlisib (BKM120) at concentrations ≥10 μM induces significant apoptosis in all tested MM cell lines at 24 h (P<0.05, compares with control). Therefore, 10 μM Buparlisib (BKM120) and 24-h treatment are chose in in the following experiments if not stated otherwise. Buparlisib (BKM120) treatment results in a dose-dependent growth inhibition in all tested MM cell lines. Buparlisib (BKM120) IC₅₀varies among tested MM cells. At 24 h treatment, IC₅₀for ARP-1, ARK, and MM.1R is between 1 and 10 μM, while IC₅₀for MM.1S is<1 μm, and ic₅₀for U266 is between 10 and 100 μM. In summary, Buparlisib (BKM120) treatment results in MM cell growth inhibition and apoptosis in dose- and time-dependent manners^[2].

In A2780 xenograft tumors, oral dosing of Buparlisib (BKM120) at 3, 10, 30, 60, and 100 mg/kg results in a dose dependent modulation of pAKT^Ser473. Partial inhibition of pAKT^Ser473is observed at 3 and 10 mg/kg, and near complete inhibition is observed at doses of 30, 60, or 100 mg/kg, respectively. Inhibition of pAKT (normalized to total AKT) tracked well with both plasma and tumor drug exposure^[1]. Mice receiving Buparlisib (BKM120) (5 μM per kg per day for 15 days) treatment has significantly smaller tumor burdens as compare with control mice, which are measured as tumor volume (P<0.05) and level of circulating human kappa chain (P<0.05). In addition, Buparlisib (BKM120) treatment significantly prolongs the survival of tumor-bearing mice (P<0.05)^[2].

446.85

Solid

C₁₈H₂₂ClF₃N₆O₂

1312445-63-8

布帕尼西盐酸盐

Room temperature in continental US; may vary elsewhere.

4°C, sealed storage, away from moisture

*In solvent : -80°C, 6 months; -20°C, 1 month (sealed storage, away from moisture)

DMSO : ≥ 50 mg/mL(111.89 mM)

*"≥" means soluble, but saturation unknown.

请根据产品在不同溶剂中的溶解度选择合适的溶剂配制储备液；一旦配成溶液，请分装保存，避免反复冻融造成的产品失效。
储备液的保存方式和期限：-80℃, 6 months; -20℃, 1 month (sealed storage, away from moisture)。-80℃ 储存时，请在 6 个月内使用，-20℃ 储存时，请在 1 个月内使用。

请根据您的实验动物和给药方式选择适当的溶解方案。以下溶解方案都请先按照In Vitro方式配制澄清的储备液，再依次添加助溶剂：

——为保证实验结果的可靠性，澄清的储备液可以根据储存条件，适当保存；体内实验的工作液，建议您现用现配，当天使用； 以下溶剂前显示的百
分比是指该溶剂在您配制终溶液中的体积占比；如在配制过程中出现沉淀、析出现象，可以通过加热和/或超声的方式助溶

• 1.

  请依序添加每种溶剂： 10% DMSO    40%PEG300   5%Tween-80   45% saline

  Solubility: ≥ 2.5 mg/mL (5.59 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (5.59 mM，饱和度未知) 的澄清溶液。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 400 μL PEG300 中，混合均匀；向上述体系中加入50 μL Tween-80，混合均匀；然后继续加入 450 μL生理盐水定容至 1 mL。

  将 0.9 g 氯化钠，完全溶解于 100 mL ddH2O 中，得到澄清透明的生理盐水溶液
• 2.

  请依序添加每种溶剂： 10% DMSO    90% (20%SBE-β-CDin saline)

  Solubility: ≥ 2.5 mg/mL (5.59 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (5.59 mM，饱和度未知) 的澄清溶液。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 900 μL20% 的 SBE-β-CD 生理盐水水溶液中，混合均匀。

  将 2 g 磺丁基醚 β-环糊精加入 5 mL 生理盐水中，再用生理盐水定容至 10 mL，完全溶解，澄清透明
• 3.

  请依序添加每种溶剂： 10% DMSO    90%corn oil

  Solubility: ≥ 2.5 mg/mL (5.59 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (5.59 mM，饱和度未知) 的澄清溶液，此方案不适用于实验周期在半个月以上的实验。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 900 μL玉米油中，混合均匀。