JANEX-1 (WHI-P131) is a potent and specificJAK3inhibitor (estimatedK_i=2.3 μM). JANEX-1 (WHI-P131) shows potent JAK3-inhibitory activity (IC₅₀of 78 μM), does not inhibitJAK1andJAK2.

JANEX-1 (WHI-P131) shows potent JAK3-inhibitory activity (IC₅₀of 78 μM), does not inhibit JAK1 and JAK2, the ZAP/SYK family tyrosine kinase SYK, the TEC family tyrosine kinase BTK, the SRC family tyrosine kinase LYN, or the receptor family tyrosine kinase insulin receptor kinase, even at concentrations as high as 350 μM. JANEX-1 induces apoptosis in JAK3-expressing human leukemia cell lines NALM-6 and LC1;19 but not in melanoma (M24-MET) or squamous carcinoma (SQ20B) cells. WHI-P131 inhibits the clonogenic growth of JAK3-positive leukemia cell lines DAUDI, RAMOS, LC1;19, NALM-6, MOLT-3, and HL-60 (but not JAK3-negative BT-20 breast cancer, M24-MET melanoma, or SQ20B squamous carcinoma cell lines) in a concentration-dependent fashion. WHI-P131 inhibits clonogenic growth in a concentration-dependent fashion with EC₅₀s of 24.4 μM for NALM-6 cells and 18.8 μM for DAUDI cells. At 100 μM, WHI-P131 inhibits the in vitro colony formation by these leukemia cell lines by >99%. In contrast, JANEX-1 does not inhibit the clonogenic growth of JAK3-negative M24-MET melanoma or SQ20B squamous carcinoma cell lines^[1].

JANEX-1 is administered at doses ranging from 5 to 100 mg/kg. Evaluation of CPK activity revealed a dose-response curve with an effective dose 50 (ED₅₀) value of 7.44 mg/kg. Mice receiving JANEX-1 displayed significantly reduced CPK and LDH levels. In addition, the infarct size of JANEX-1-treated mice (30.16±2.79%) is significantly decreased when compared with I/R-operated mice (65.64±3.76%)^[2]. JANEX-1 (WHI-P131) is absorbed rapidly, and the time to reach the maximum plasma JANEX-1 concentration (t_max) is 24.7±1.7 min. JANEX-1 is rapidly eliminated with an elimination half-life of 45.6±5.5 min. Although the predicted maximum plasma JANEX-1 concentration is 10.5 ± 0.8 μM, which is only half of the C_maxfollowing i.v. administration of the same bolus dose, the i.p. bioavailability is 94.6% and the systemic exposure levels (i.e., AUC) are very similar to those observed after i.v. injection (17.1±2.2 μMoh versus 18.1±1.2 μMoh)^[3].

297.31

Solid

C₁₆H₁₅N₃O₃

202475-60-3

Room temperature in continental US; may vary elsewhere.

DMSO : ≥ 100 mg/mL(336.35 mM)

*"≥" means soluble, but saturation unknown.

请根据产品在不同溶剂中的溶解度选择合适的溶剂配制储备液；一旦配成溶液，请分装保存，避免反复冻融造成的产品失效。
储备液的保存方式和期限：-80℃, 6 months; -20℃, 1 month。-80℃ 储存时，请在 6 个月内使用，-20℃ 储存时，请在 1 个月内使用。

请根据您的实验动物和给药方式选择适当的溶解方案。以下溶解方案都请先按照In Vitro方式配制澄清的储备液，再依次添加助溶剂：

——为保证实验结果的可靠性，澄清的储备液可以根据储存条件，适当保存；体内实验的工作液，建议您现用现配，当天使用； 以下溶剂前显示的百
分比是指该溶剂在您配制终溶液中的体积占比；如在配制过程中出现沉淀、析出现象，可以通过加热和/或超声的方式助溶

• 1.

  请依序添加每种溶剂： 10% DMSO    40%PEG300   5%Tween-80   45% saline

  Solubility: ≥ 2.5 mg/mL (8.41 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (8.41 mM，饱和度未知) 的澄清溶液。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 400 μL PEG300 中，混合均匀；向上述体系中加入50 μL Tween-80，混合均匀；然后继续加入 450 μL生理盐水定容至 1 mL。

  将 0.9 g 氯化钠，完全溶解于 100 mL ddH2O 中，得到澄清透明的生理盐水溶液
• 2.

  请依序添加每种溶剂： 10% DMSO    90% (20%SBE-β-CDin saline)

  Solubility: ≥ 2.5 mg/mL (8.41 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (8.41 mM，饱和度未知) 的澄清溶液。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 900 μL20% 的 SBE-β-CD 生理盐水水溶液中，混合均匀。

  将 2 g 磺丁基醚 β-环糊精加入 5 mL 生理盐水中，再用生理盐水定容至 10 mL，完全溶解，澄清透明
• 3.

  请依序添加每种溶剂： 10% DMSO    90%corn oil

  Solubility: ≥ 2.5 mg/mL (8.41 mM); Clear solution

  此方案可获得 ≥ 2.5 mg/mL (8.41 mM，饱和度未知) 的澄清溶液，此方案不适用于实验周期在半个月以上的实验。

  以 1 mL 工作液为例，取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 900 μL玉米油中，混合均匀。